Monthly Maintenance; Quarterly Maintenance; Battery Maintenance; Transporting Machine - Nobles Speed Scrub 2401 Manual Del Operador Y Piezas

OPERATION
3. Check fluid level in battery cells. (See BATTERY
MAINTENANCE).
4. Clean battery tops with to prevent corrosion. (See

BATTERY MAINTENANCE).

5. Check for loose or corroded battery cables.

MONTHLY MAINTENANCE

(Every 80 Hours of Operation)
1. Lubricate caster grease fittings with a water
resistant grease.
2. Lubricate all linkage pivot points with silicone
spray then coat with a water resistant grease to
maintain a smooth operation.
3. Check machine for water leaks and loose nuts and
bolts.

QUARTERLY MAINTENANCE

(Every 250 Hours of Operation)
Check drive, vacuum and brush motors for carbon
brush wear, replace brushes if worn to a length of
10mm (0.38 in) or less.
BATTERY MAINTENANCE
WARNING: Batteries emit hydrogen gas.
Explosion or fire can result. Keep sparks and
open flame away. Keep battery compartment open
when charging.
FOR SAFETY: When servicing machine, wear
protective gloves when handling batteries and
battery cables. Avoid contact with battery acid.
1. Always follow proper charging instructions (See
BATTERY CHARGING).
2. After charging, check fluid level (A) in each battery
cell of all batteries. The level should reach bottom
of sight tubes (B). If needed, add just enough
distilled water to reach bottom of sight tubes. DO
NOT overfill (Figure 29).
B
A
FIG. 29
14
Home Find... Go To..
3. Keep battery tops and terminals clean and dry.
To clean batteries:
a. Mix a strong solution of baking soda and
water.
b. Brush solution sparingly over battery tops,
terminal and cable connectors.
NOTE: Do not allow baking soda solution to enter
battery cells.
c. Use wire brush to clean terminal post and
cable connections.
d. After cleaning, apply a coating of clear battery
post protectant to terminals and cable
connections.
4. Check for loose or worn cables. Replace if worn.

TRANSPORTING MACHINE

When transporting machine by use of trailer or truck,
be certain to follow tie–down procedures below:
FOR SAFETY: When using machine, go slow on
inclines and slippery surfaces.
1. Remove squeegee from machine and raise scrub
head. Leave pad or brush installed.
2. Load machine using a recommended loading
ramp.
3. Position front of machine up against front of trailer
of truck. Once machine is positioned, lower brush
head.
4. Place a block behind the drive wheel and the rear
casters.
5. Place tie–down straps over top of machine and
secure straps to floor. It may be necessary to
install tie–down brackets to the floor of your trailer
or truck.
Speed Scrubt 2401/2601 (08–01)