Nobles Speed Scrub 2401 Manual Del Operador Y Piezas página 9

5. Lower scrub head to floor by pressing bottom half
(+) of brush pressure switch (Figure 13).
FIG. 13
6. Turn vacuum and brush switches to the on
position.
NOTE: The brushes and solution flow will not start
until control grips are rotated.
7. Before starting, turn speed control knob to slowest
setting
(Figure 14).
8. Begin scrubbing by rotating control grips forward.
Gradually increase your speed by turning speed
control knob forward
(Figure 14).
FIG. 14
9. Once machine begins to move, check the needle
position of the brush pressure meter. Depress
brush pressure switch to adjust brush pressure.
Never operate machine in the red zone
(Figure 15).
Speed Scrubt 2401/2601 (08–01)
Home Find... Go To..
FIG. 15
ATTENTION: To prevent floor damage and brush
motor overload, do not operate brush pressure
meter in red zone.
10. To operate machine in reverse, simply pull reverse
switch backwards (one speed)
(Figure 16).
FIG. 16
11. To stop machine, release control grips.
OPERATION
9