Publicidad
Idiomas disponibles
Idiomas disponibles
INSTALLATION
11
Unpacking
Your Re{rigerafor
"-//_
WARNING
• Use two or more people to move and
install the refrigerator.
Failure to do so
can result in back or other injury.
Your refrigerator
is heavy. When moving
the refrigerator
for cleaning or service,
be sure to protect the floor. Always pull
the refrigerator
straight out when moving
it. Do not wiggle or walk the refrigerator
when trying to move it, as floor damage
could occur.
Keep flammable
materials and vapors,
such as gasoline, away from the
refrigerator.
Failure to do so can result in
fire, explosion, or death.
Remove tape and any temporary labels from your
refrigerator before using. Do not remove any
warning-type labels, the model and serial number
label, or the Tech Sheet that is located under the
front of the refrigerator.
To remove any remaining tape or glue, rub the
area briskly with your thumb. Tape or glue residue
can also be easily removed by rubbing a small
amount of liquid dish soap over the adhesive with
your fingers. Wipe with warm water and dry.
Do not use sharp instruments, rubbing alcohol,
flammable fluids, or abrasive cleaners to remove
tape or glue. These products can damage the
surface of your refrigerator.
Refrigerator shelves are installed in the shipping
position. Please reinstall shelves according to
your individual storage needs.
Choosing
fhe
Proper
Locafion
• Select a place where a water supply can
be easily connected
for the automatic
icemaker.
@ NOTE
/
The water pressure must be between 20
and 120 psi (140 and 830 kPa)on models
without a water filter and between 40 and
120 psi (280 and 830kPa) on models with
The refrigerator should always be plugged
into its own individual properly grounded
electrical outlet rated for 115 Volts, 60 Hz,
AC only, and fused at 15 or 20 amperes.
This provides the best performance
and also prevents overloading house
wiring circuits which could cause a fire
hazard from overheated
wires. It is
recommended
that a separate circuit
serving only this appliance be provided.
T A
WARNING
o reduce the risk of electric shock, do not
install the refrigerator in a wet or damp
area
j
Flooring
To avoid noise and vibration, the unit must be
leveled and installed on a solidly constructed
floor. If required, adjust the leveling legs to
compensate
for unevenness of the floor. The
front should be slightly higher than the rear to
aid in door closing. Leveling legs can be turned
easily by tipping the cabinet slightly. Turn the
leveling legs to the left to raise the unit or to
the right to lower it. (See Leveling and door
Alignment.)
@
NOTE
Installing on carpeting, soft tile surfaces
a platform or weakly supported structun
Publicidad
