Publicidad
Idiomas disponibles
Idiomas disponibles
48
TROUBLESHOOTING
Not dispensing
water
New installation
or water line
recently connected.
Dispense 25
gallons (9 litters) of water (flush for
approximately
5 minutes)
to remove trapped
air
and contaminates
from the system
Do not dispense
the entire2 5 gallons (9 lifters)
amount
continuously.
Depress and release the
dispenser
pad for cycles of 30 seconds
ON and
60 seconds
OFF
The dispenser
panel is locked
Press and hold the Lock button
for three
seconds
to unlock the control panel and dispenser
The dispenser
is not set for
The dispenser
can be set for ice or water
Make
water dispensing
certain that the control panel is set for the proper
operation
Press the Water button
on the control
panel to dispense
water
Refrigerator
or freezer
doors are
Water will not dispense
if any of the refrigerator
not closed
properly
doors are left open
Water filter has been recently
removed
or replaced
Tubing connecting
refrigerator
to house supply valve is kinked
The house water supply is not
connected,
the valve is not
turned on fully, or the valve is
clogged
After the wafer filter is replaced,
dispense
2.5
gallons (9 litters) of water (flush for approximately
5 minutes)
to remove trapped
air and contaminates
from the system
Do not dispense
the entire2
5
gallons (9 litters) amount
continuously.
Depress
and release the dispenser
pad for cycles of 30
seconds
ON and 60 seconds
OFF
The tubing
can kink when the refrigerator
is
moved during
installation
or cleaning
resulting
in
reduced
wafer flow. Straighten
or repair the water
supply line and arrange
if to prevent future
kinks
Connect
refrigerator
to the water supply and turn
the water shutoff valve fully open
If the problem
persists, it may be necessary to
contact
a plumber
Publicidad
