Setting The Panel Input Key - Yamaha YSP-4000 Manual De Instrucciones

5
Press / to switch between "DEMO: ON"
and "DEMO: OFF".
• Select DEMO: ON to activate the demo mode.
• Select DEMO: OFF to deactivate the demo mode.
6
Press STANDBY/ON on the remote control to
set this unit to the standby mode.
STANDBY/ON
The new setting will be activated when you turn on
the power of this unit next time.
Press ENTER while playing back sources to test the
sound beam.
The sound beam being output shuttles between left
and right. Press ENTER again to stop shuttling.
ENTER
Adjusting the system parameters

Setting the PANEL INPUT KEY

You can disable the INPUT on the front panel when you
adjust the system parameters.
1
Repeat steps 1 to 3 in "Using the system
parameters" on page 94.
2
Set the operation mode selector to YSP.
TV/AV
YSP
3
Press / so that "PANEL INPUT KEY" is
displayed in the front panel display.
4
Press ENTER.
ENTER
ENTER
99
En