Publicidad
Idiomas disponibles
Idiomas disponibles
must be at least 150mm between them.
The Refrigerator must be installed on a
completely flat surface; leave between 5
and 10 cm on both sides of the appliance,
7,5 cm between the back part and the
wall and 10 cm between the top part of
the appliance and the ceiling. A wrong
positioning could lead to increasing the
noise level.
It is possible to install certain appliances
without a minimum distance. Check with
an authorized dealer or kitchen designer.
Reversible doors
The side on which the refrigerator door opens
can be changed from the right side to the
left side if required by your installation site.
When changing the door, make sure that
the appliance is completely turned off
and disconnected from the power supply.
Note: It is recommended to call a technician
or professional to change the opening side
of the door.
Follow the steps below to change the door
(see Figure 03 on page 5):
Note: During this step, please hold the door
with your hands to prevent it from falling.
• Remove the screws securing the top
cover and remove it.
• Remove the two screws securing the
right upper hinge to the structure and
remove.
• Lift the door and place it on a padded
surface to prevent scratching.
• Remove the two screws securing the
lower hinge and remove.
• Remove the front foot and pass to the
right side.
• Before inserting the lower hinge remove
the plug and reverse the direction of
the lower hinge. Then install the lower
hinge on the left side of the lower
structure with two screws.
• Fit the plug in the lower hinge.
• Place the door in the correct position
ensuring that this is supported on the
lower hinge.
• Keeping the door in the closed position
secure the upper hinge on the left side
of the upper structure with two screws.
Remember not to tighten the screws
until the top of the door is level with
respect to the upper structure.
• Install the top cover in the part above
the apparatus using the screws.
USING THE APPLIANCE
This appliance is designed for household
use only, for refrigerating food. Never use
the appliance for purposes other than those
for which it was designed.
This appliance is simple to use and does
not require a great deal of knowledge, but
please read all the instructions described
here for correct use.
Before the first use
Before using the appliance, remove all
packaging, including corks and rubber
straps. Adjust the legs and clean the
exterior and interior of the fridge with a
warm cloth. Do not start the appliance
immediately after installation. It should
be started after the appliance has been
standing for 2 to 6 hours to ensure its
proper operation.
To prevent damage to the power cable and
any resulting incidents, it must be well
protected.
Before turning it on, please check if the
voltage range of the fridge is the same as
that of the power supply. When the fridge
is first installed, allow it to become stable
at normal operating temperatures for 2-3
hours before filling it with fresh or frozen
food. If the operation is interrupted, wait 5
minutes before restarting.
Please note that the fridge cavity is equipped
with an electrical temperature sensor. This
sensor detects the temperature inside the
fridge and helps the compressor to operate
EN
35
Publicidad
