Publicidad
Idiomas disponibles
Idiomas disponibles
Not all of the accessories illustrated and
described are included as standard.
Technical Data
Biscuit joiner cutter
Order number
Rated power
Idle speed
Max. groove depth
Groove width
Swivel range
Cutter Ø
Holder Ø
Spindle thread
Weight approx.
Protection class
Before start-up (fig. II)
Attention!
Prior to use, check that the specifications of your
mains power supply correspond to the mains
voltage and mains frequency indicated on the
name plate.
Observe mains voltage: The mains voltage must
conform with the voltage specified on the type plate
of your device. 230 V labelled devices can also be
operated at 220 V.
Adjusting the cutting depth
Adjust the cutting depth using the adjustment dial
according to the selected wood jointing biscuits or
1
wood patches.
Size
Setting
No. 0
0
No. 10
10
No. 20
20
Simplex
S
Duplex
D
Maximum
MAX
16
HVF 800
5706 200 1
800 W
10,000 rpm
19 mm
Cutter-dependent
0–90 °
100 mm
22 mm
M 10
Approx. 3.24 kg
(without cable)
/II
Cutting depth
8.0 mm
10.0 mm
12.0 mm
13.0 mm
14.7 mm
19.0 mm
Adjusting the cutting angle
Undo the left clamping lever, set the pivoting fence
at the desired angle according to the scale (e.g.
for mitre joints) and retighten the clamping lever.
The main angles of 22.5°, 45° and 67.5° can be
quickly set via a ball detent.
If the tightened clamping lever gets in the
way when working, then it can be moved
to another position by pulling out without
the clamp coming loose.
Start-up
Risk of severe injuries.
Always guide the machine with both
¾
hands.
First switch on, then bring the
¾
attachment into contact with the
workpiece.
Danger of unintentional starting
Always switch off the machine when
¾
the mains plug is removed from the
plug socket or if a power failure has
occurred.
Switching on/off
Switch ON
▸
Push the sliding switch forward and to lock press
down in the forward region.
Switch OFF
▸
Press the sliding switch down in the rear region,
the switch returns automatically to the 0-position.
2
3
WARNING!
WARNING!
Publicidad
