INSTALLATION AND WIRE
CONNECTION MANUAL
Contents
1. BEFORE STARTING............................................................................................................. 39
2. PACKAGE CONTENTS............................................................................................................ 39
3. GENERAL CAUTIONS ............................................................................................................ 39
6. CAUTIONS ON WIRING .......................................................................................................... 43
7. WIRE CONNECTION ............................................................................................................. 44
1. BEFORE STARTING
1. This set is exclusively for use in cars with a
negative ground 12 V power supply.
2. Read these instructions carefully.
3. Be sure to disconnect the battery "- " terminal
before starting. This is to prevent short circuits
during installation. (Figure 1)
2. PACKAGE CONTENTS
1. Main unit
2. Manuals
Owner's manual & Installation manual
Warranty card
3. Power supply cord
4. Bag for accessories (No. 1)
3. GENERAL CAUTIONS
1. Do not open the case. There are no user-
serviceable parts inside. If you drop anything
into the unit during installation, consult your
dealer or an authorized Clarion service
center.
5. Remote control unit
6. Battery
(installed in remote control unit)
7. Finishers
2. Use a soft, dry cloth to clean the case. Never
use a rough cloth, thinner, benzine, or alcohol,
etc. For tough dirt, apply a little cold or warm
water to a soft cloth and wipe off the dirt
gently.
Car battery
Figure 1
39
VX409/VZ409