Clearing The Memory - boso medicus PC 2 Manual Del Usuario

The memory
The boso-medicus PC 2 stores up to 325 measure-
ments. If the memory is full, (symbol
display mode), the oldest measurement is cleared from
memory and the most recent value stored.
You can recall stored readings by switching on the unit
and pressing and holding down the START/STOP butt-
on until the last measurement that has been stored
M
M on the time
appears in the display
(symbol ).
M
Now all the stored measurement readings are shown
successively for three seconds. (If no measurements
are stored in memory, the systolic, diastolic and pulse
readings all show the value '0' for three seconds.)
By pressing the START/STOP button again, the
memory display is interrupted and a new measure-
ment started.

Clearing the memory

Press the SET button for approximately five seconds
until the symbol starts to flash.
M
The memory is now clear.
69