Publicidad
Step 6
Separate the LONG EXTENSION SLIDES (3) from the LONG EXTENSION RAILS (2) as shown in the enlarged
å
diagram below. Be prepared, the parts are greasy.
Fasten two LONG EXTENSION RAILS (2) to the ENDS (QQ and RR). Use six BLACK 1/2" PAN HEAD SCREWS (31).
å
NOTE: For each EXTENSION RAIL, turn a SCREW into the hole shown in the enlarged diagram. Then, slide the inner
å
cartridge of the EXTENSION RAIL in to fi nd the other holes that lines up with the holes in the ENDS. Turn a SCREW
into this hole.
NOTE: The LONG EXTENSION SLIDES will be used later for the LARGE DRAWER.
å
Push the black lever up and
pull the SLIDE from the RAIL.
Edge with
HIDDEN CAMS
Open end
433361
3
Edge with
HIDDEN CAMS
RR
2
www.sauder.com
2
Use these holes.
QQ
2
BLACK 1/2" PAN HEAD SCREW
(6 used in this step)
Open end
31
Page 11
Publicidad
