Publicidad
Step 6
å
Separate the LONG EXTENSION SLIDES (3) from the LONG EXTENSION RAILS (2) as shown in the enlarged
diagram below. Be prepared, the parts are greasy.
å
Fasten two LONG EXTENSION RAILS (2) to the ENDS (QQ and RR). Use six BLACK 1/2" PAN HEAD SCREWS (31).
å
NOTE: For each EXTENSION RAIL, turn a SCREW into the hole shown in the enlarged diagram. Then, slide the inner
cartridge of the EXTENSION RAIL in to find the other holes that lines up with the holes in the ENDS. Turn a SCREW
into this hole.
å
NOTE: The LONG EXTENSION SLIDES will be used later for the LARGE DRAWER.
Push the black lever up and
pull the SLIDE from the RAIL.
Edge with
HIDDEN CAMS
Open end
433361
3
Edge with
HIDDEN CAMS
RR
2
www.sauder.com
2
Use these holes.
QQ
2
BLACK 1/2" PAN HEAD SCREW
(6 used in this step)
Open end
31
Page 11
Publicidad
