Publicidad
Step 12
å
Separate the EXTENSION SLIDES (5) from the EXTENSION RAILS (4) as shown in the enlarged diagram below. Be
prepared, the parts are greasy.
å
Fasten two EXTENSION RAILS (4) to the RETURN UPRIGHT (SS) and RETURN RIGHT END (ZZ). Use six BLACK 1/2"
PAN HEAD SCREWS (31).
å
NOTE: For each EXTENSION RAIL, turn a SCREW into the hole shown in the enlarged diagram. Then, slide the inner
cartridge of the EXTENSION RAIL in to find the other holes that lines up with the holes in the UPRIGHT and END. Turn
a SCREW into this hole.
å
NOTE: The EXTENSION SLIDES will be used later for the RETURN DRAWER.
Push the black lever up and
pull the SLIDE from the RAIL.
Open end
BLACK 1/2" PAN HEAD SCREW
(6 used in this step)
433361
5
Edge with
HIDDEN CAMS
4
SS
31
www.sauder.com
4
Use these holes.
4
ZZ
Edge with
HIDDEN CAMS
Open end
Page 17
Publicidad
