Publicidad
Step 12
Separate the EXTENSION SLIDES (5) from the EXTENSION RAILS (4) as shown in the enlarged diagram below. Be
å
prepared, the parts are greasy.
Fasten two EXTENSION RAILS (4) to the RETURN UPRIGHT (SS) and RETURN LEFT END (YY). Use six BLACK 1/2"
å
PAN HEAD SCREWS (31).
NOTE: For each EXTENSION RAIL, turn a SCREW into the hole shown in the enlarged diagram. Then, slide the inner
å
cartridge of the EXTENSION RAIL in to fi nd the other holes that lines up with the holes in the UPRIGHT and END. Turn
a SCREW into this hole.
NOTE: The EXTENSION SLIDES will be used later for the RETURN DRAWER.
å
Push the black lever up and
pull the SLIDE from the RAIL.
Open end
BLACK 1/2" PAN HEAD SCREW
(6 used in this step)
433361
5
4
4
YY
31
www.sauder.com
Use these holes.
Edge with
HIDDEN CAMS
4
SS
4
Edge with
HIDDEN CAMS
Open end
Page 17
Publicidad
