Cleaning And Maintenance; Cleaning Side Brushes - cecotec CONGA Manual De Instrucciones

ENGLISH
2. Edge mode: the display will show MODE 1 and the robot will clean along the edges.
3. Area mode: the display will show MODE 2 and the robot will clean a 2*2 m area.
4. Random mode: the display will show MODE 3 and will start cleaning in a random way.
5. DeepCleaning mode: the display will show MODE 4 and the robot will clean over the same
spot 2 times for a deeper cleaning.
6. Scrubbing mode
Press the button to enter the water-intensity mode and select the desired intensity and
select between 1, 2 or 3 (see WATER INTENSITY/TIME SETTINGS section).
• Do not use the mop outdoors.
• Remove the carpets before operating the robot under this mode.
• During operation, control the water level on the water tank. If it empties, fill it up
again before continuing scrubbing.
• Take the water tank and the mop out before charging the robot.
Note: in order to ensure perfect scrubbing, moisten the mop before starting scrubbing.
7. Schedule cleaning
• The robot can be programmed to operate automatically
at the desired time.
8. Magnetic restricted area
• Use the magnetic stripe provided to delimit a certain
zone, to which the robot will not be able to access and clean.
• For example, place the magnetic stripe from one door's frame to the other in order
to forbid the robot from crossing to a room.

5. CLEANING AND MAINTENANCE

CLEANING SIDE BRUSHES

• Make sure the side brushes are in good conditions.
• If the bristles are deformed, introduce the side brush into water.
• Clean them regularly in order to keep them in good conditions.
CLEANING WATER, DUST TANK AND FILTERS
• Empty and clean the dust tank after each use.
• Wash the filters each 15-30 days to lengthen their service life.
• Dry completely the filters before placing them back in their position.
• Do not expose the filters to direct sunlight.
• The maximum service life of the primary and EPA filter is 6 months.
28