Troubleshooting - cecotec CONGA Manual De Instrucciones

6. TROUBLESHOOTING

Error Reason
The power
1 switch is off
while charging
Left side
2 free-fall sensor
error
Right side
3 free-fall sensor
error
Front free-fall
4
sensor error
Left wheel off
5
the ground
Right wheel off
6
the ground
Left side
7 anti-collision
sensor error
Right side
8 anti-collision
sensor error
Front anti-co-
9 llision sensor
error
10 Left wheel error
Right wheel
11
error
Left-side brush
12
error
Right-side
13
brush error
14 Fan motor error
Main brush
15
error
Low battery
17
Note:
If none of the solutions solve the problem, try the below steps:
1. Switch off and switch back on the robot.
2. Contact the Technical Support Service of Cecotec.
Solution
Check if the power
switch is on or off and
turn it on
Place the robot on a
flat stable surface
Clean or unblock the
front bumper
Ckeck if the wheel or
brush is entangled or
blocked and clean it
Charge the robot
Button display
The robot's display
flashes quickly
The robot's display
lights up in blue and
flashes quickly
The robot's display
lights up in blue and
flashes slowly
The robot's display
lights up steady red
and blue
The robot's display
flashes switching from
blue to red
Battery indicator light
lights up red
ENGLISH
Beeps
1 long beep
1 long beep
1 long beep
1 long beep
1 long beep
1 long beep
1 long beep
1 long beep
1 long beep
1 long beep
1 long beep
1 long beep
1 long beep
1 long beep
1 long beep
4 short beeps
31