Webasto ProCore Edge 9 Manual De Operación Y Mantenimiento página 33

IOMM
5.1.2. Table 1 describes the bare-ended signal connections that
can be connected to the charger via this connector.
Table 1 Bare-Ended Signal Connections
Connection
Pin 10
Pin 9
Pin 8
Pin 7
Pin 6
Pin 5
Pin 4
Pin 3
Pin 2
Pin 1
The connector can accept up to a 16 AWG wire.
CAUTION
Use only copper wires.
Webasto Charging Systems, Inc.
Description
CAN1-L/DATA – RED
CAN1-H/DIR (Direction) – WHITE
PILOT – GREEN
PILOT RETURN – BLACK
SWA and SWB (DCT pins 6 and 5, respectively)
are for an external pilot interlock connection. In
order to charge, these pins must be shorted either
by a normally closed pilot interlock connection
or by a jumper. A jumper between these pins is
factory installed to ensure the unit operates when
it reaches a destination.
Negative lead connecting and controlling the
24-VDC
WATERING VALVE
Positive lead connecting the 24-VDC WATER-
ING VALVE
Negative lead to the SPARE RELAY
Positive lead to the SPARE RELAY
ProCore Edge North America
33 of 68
31241-03-0202