Publicidad
Idiomas disponibles
Idiomas disponibles
2.
Close the washer
door by pushing
it firmly
until the lock clicks. The washer
door will
remain
locked during
the wash cycle.
NOTE: After any wash cycle is completed,
the door must be opened
and then closed
before a new cycle can begin. The door can be opened
only if PAUSE/OFF is selected
while
the ADD A GARMENT
light is glowing
or if the cycle has been canceled.
See "To
cancel a cycle"
in "Changing
Cycles, Options
and Modifiers"
section.
3.
Open
the dispenser
drawer
and add laundry
products
to the detergent,
bleach,
or fabric
softener compartments.
Close drawer
slowly
to avoid spills.
See "Using
the Dispenser."
4.
Turn on the washer
by selecting
CONTROl_
ON.
Select one of the cycles by turning
the
cycle selector.
The indicator
light for the selected cycle will glow. When
selecting
a wash
cycle, the preset Options,
Water Temp, Spin Speed, and Soil I.evel for the selected
cycle
will glow. The display
shows the estimated
time remaining.
The preset settings provide
the
recommended
fabric care for the selected
cycle. See "Cycles."
5.
Select the desired
Options,
such as Oxi
Prewash,
Auto Soak, Extra Rinse and Rinse Hold.
Not all options
are available
with all cycles. See "Options."
6.
Select the desired
Modifiers,
such as Soil I_evel, Water Temp, Spin Speed and Cycle
End
Signal. Not all modifiers
are available
with all cycles
and options.
See "Modifiers."
7.
If desired,
select the CYCI_E END SIGNAl_. The signal is helpful
when you are washing
items that should
be removed
from the washer
as soon as it stops. Select I.oud, Soft or
OFF.
8.
To begin the wash cycle immediately
Select HOI.D
TO START.
•
If you do not select HOI.D
TO START within
5 minutes
of choosing
a cycle, the
washer
automatically
shuts off.
When
the wash cycle is complete,
the CYCI_E COMPI.ETE
status light glows,
the door
unlocks,
and the wash load can be removed
from the washer.
The washer
powers
down automatically
5 minutes
after the cycle is complete
and the CYCI_E COMPI.ETE
light goes off. To power
down the washer
manually
after the wash cycle is complete,
select
PAUSE/OFF once.
Your new washer
has a dispenser
drawer with
four separate compartments
for your laundry
products--two
are for detergent,
one is for liquid
chlorine
bleach,
and one is for liquid
fabric
softener.
I.aundry
products
are diluted
and dispensed
automatically
at the proper time during
the wash cycle, making
it unnecessary
for you to return to the washer
during
the cycle to add
them.
It is normal
for small amounts
of water to remain
in the dispensers
when the wash cycle is
complete.
I)o not put laundry
products
directly
into the wash tub. Always
use the proper
dispensers
when adding
laundry
products.
Choosing
the
Right Detergent
Use only High Efficiency
detergents.
The package
for this type of detergent
will be marked
"HE" or "High
Efficiency."
This wash system, along with
less water, will create too much
sudsing
with
a regular non-HE
detergent.
Using regular detergent
will
likely
result in washer
errors,
longer cycle times and reduced
rinsing
performance.
It may also result in component
failures
and noticeable
mold or mildew.
HE detergents
are made to produce
the right amount
of suds for the best performance.
Follow
the manufacturer's
instructions
to determine
the
amount
of detergent
to use.
Use only HE High Efficiency detergent.
To fill dispenser
compartments
1.
Pull out the dispenser
drawer.
2.
Add the desired
laundry
product
to the proper
compartment.
3.
Push in the dispenser
drawer
slowly
and completely
(to avoid a spill).
F
Dispenser
A. Oxi Prewash
detergent
compartment
B. Separator
C. Main
Wash detergent
compartment
D. Dispenser
release
lever
E. Chlorine
bleach
compartment
E Fabric
softener
compartment
14
....
...................................................................................................................................................................................................................................................
Publicidad
