Publicidad
Idiomas disponibles
Idiomas disponibles
•
This washer
is equipped
with a power supply
cord having
a 3 prong grounding
plug.
•
To minimize
possible
shock hazard,
the cord must be plugged
into a mating,
3 prong,
grounding-type
outlet,
grounded
in accordance
with
local codes and ordinances.
If a
mating outlet
is not available,
it is the personal
responsibility
and obligation
of the
customer
to have the properly
grounded
outlet
installed
by a qualified
electrician.
•
If codes permit
and a separate ground
wire is used, it is recommended
that a qualified
electrician
determine
that the ground
path is adequate.
•
Do not ground
to a gas pipe.
•
Check with
a qualified
electrician
if you are not sure the washer
is properly
grounded.
•
Do not have a fuse in the neutral
or ground
circuit.
GROUNDING
iNSTRUCTiONS
For a grounded,
cord=connected
washer:
This washer must be grounded, in the event of a malfunction
or breakdown, grounding will reduce the risk of electrical
shock by providing a path of least resistance for electric
current. This washer is equipped with a cord having an
equipment-grounding
conductor and a grounding plug. The
plug must be plugged into an appropriate outlet that is
properly installed and grounded in accordance with all local
codes and ordinances.
WARNING:
improper connection of the equipment-
grounding conductor can result in a risk of electric shock.
Check with a qualified electrician or serviceman if you are in
doubt as to whether the appliance is properly grounded.
Do not modify the plug provided with the appliance - if it will
not fit the outlet, have a proper outlet installed by a qualified
electrician.
For a permanently
connected
washer:
This washer must be connected to a grounded metal,
permanent wiring system, or an equipment grounding
conductor must be run with the circuit conductors and
connected to the equipment-grounding
terminal or lead on
the appliance.
Excessive
Weight
Hazard
Use two or more people
to move and install
washer.
Failure
to do so can result
in back or other
injury.
IMPORTANT:
Position
the washer
so that the rear of the washer
is within
approximately
3 ft (90 cm) of its final location.
There are 4 bolts in the rear panel of the washer
that support
the suspension
system during
transportation.
These bolts also retain the power
cord inside the washer
until the bolts are
removed.
1.
Using a 13 mm wrench,
loosen each of the bolts.
2.
Once the bolt is loose, move it to the center of the hole and completely
pull out the bolt,
including
the plastic
spacer covering
the bolt.
i_ i¸
!ii .............
iiiiiiiiiii
3.
Once all 4 bolts are removed
discard
bolt and spacers. Then pull the power cord through
the opening
of the rear panel and close the hole with
the attached
cap.
4.
Close the bolt holes with
the 4 transport
bolt hole plugs.
NOTE: If the washer
is to be transported
at a later date, call your local service center. To avoid
suspension
and structural
damage
to your washe_; it must be properly
set up for relocation
by
a certified
technician.
Publicidad
