Publicidad
Idiomas disponibles
Idiomas disponibles
Washer won't start
Electrical Shock Hazard
Plug into a grounded 3 prong outlet.
Do not remove ground prong.
Do not use an adapter.
Do not use an extension cord.
Failure to follow these instructions can result in death,
fire, or electrical shock.
•
Check the following:
Is the power
cord plugged
into a grounded
3 prong outlet?
Is the washer
door firmly
closed?
Has a cycle been selected,
but HOI.D
TO START has not been selected
and held for
1 second?
Was the door open
after completion
of last cycle?
Washer
won't
fill,
wash
or rinse
Check the following:
Is the power
cord plugged
into a grounded
3 prong outlet?
Is there power
at the plug? Check electrical
source or ca[[ an electrician.
Are the hot and cold water faucets
turned on?
Is the water inlet hose kinked?
Are the water inlet valve screens clogged?
Turn off the water and remove
inlet hoses from the washer.
Remove any accumulated
film
or particles.
Reinstall
hoses, turn water on and check for leaks.
Washer
stops
•
Check the following:
Is the power cord plugged into a grounded 3 prong outlet?
Is there power at the plug?
Check electrical source or ca[[ an electrician.
Has a household
fuse blown,
or has a circuit
breaker tripped?
Replace the fuse or reset the
circuit
breaker. If the problem
continues,
ca[[ an electrician.
Are you using an extension
cord?
Do not use an extension
cord.
Washer
won't
drain
or spin
•
Is the drain hose clogged, or the end of the drain hose more than 96" (2.4 m) above the
floor?
i_,_ i¸
•
Is your voltage low?
Check electrical
source or call electrician.
Do not use an extension
cord.
•
Is the"SUD"
routine
active?
Cycle
will complete
once extra suds are removed.
•
Is the load balanced?
A single or bulky
item may cause imbalance.
Add more items or redistribute
the load.
Washer
makes
noise or vibrates
Is the washer level?
The washer
must be [eve[. The four feet should
be properly
installed,
and the nuts should
be tightened
against the washer
cabinet.
As water
is drained
from the washe_, you may hear air being pulled
through
the pump.
This happens
during
the end of draining.
It is normal.
Are you washing items with metal snaps, buckles or zippers?
YOu may hear metal items touching
the washer drum. This is normal.
Is washer installed
on a sturdy and solid floor?
Refer to the "Installation
Instructions"
for flooring
requirements.
Noise and vibration
may
be reduced
by placing
a piece of ;/4" (1 9.1 mm) plywood
underneath
your washer. The
plywood
may extend
underneath
both washer
and dryer to keep them at equal heights.
Washer
leaks
•
Check household plumbing for leaks.
Publicidad
