Descargar Imprimir esta página

Maytag EPIC MFW9800TQ0 Manual De Uso Y Cuidado página 24

Lavadora automatica de carga frontal

Publicidad

Idiomas disponibles

Idiomas disponibles

Dispensers clogged or leaking
Are the laundry products in the correct dispenser compartment?
Add the correct
amounts
of detergent,
fabric
softener or liquid
chlorine
bleach
to the
correct
compartments.
Add powdered
or liquid
color-safe
bleach
to the Main Wash
compartment.
Be sure to match powdered
color-safe
bleach
with
powdered
detergent
or
match liquid
color-safe
bleach
with
liquid
detergent.
Is the detergent separator
in the correct position?
Separator should
be in the front position
when using liquid
detergent
and in the back
position
when using powdered
detergent.
Washer
odor
See "Cleaning
Your Washer."
Are you using HE detergent?
Use of non-HE
detergent
can cause a film residue which
can result in odor.
Did you leave the door open after use?
This washer
has a tight sea[ to avoid water
leaks. To avoid odors
leave the door open to
allow the washer to dry between
uses.
Load too wet
Did you use the right
cycle for the load being washed?
Select a cycle with a higher
spin speed.
Did you wash a single
item or bulky items or have you overloaded
the washer?
A single item, bulky
items, or overloading
may cause imbalance.
Add items or try to
evenly
distribute
your wet laundry
in the drum, and start a L-)rain/Spin cycle.
If the laundry
is still wet, take haft of the load out of the washer
and try again.
Residue or lint on load
Did you add detergent
to the dispenser?
For best results, add detergent
to the detergent
compartment.
Do not add detergent
to the
washer
drum.
Did you sort properly?
Sort lint givers (towels, chenille) from lint takers (corduroy, synthetics). Also sort by color.
Did you overload
the washer?
Do not overload
the washer.
The washer
can be fully
loaded,
but not tightly
packed.
The
wash load must be balanced.
I.int can be trapped
in the load if overloaded.
Check the following:
Was paper or tissue left in pockets?
Did you use enough HE detergent?
Use enough
detergent
to remove
lint and hold it in suspension.
Use only
HE detergent.
Follow
the manufacturer's
instructions
to determine
the amount
of detergent
to use.
Is your water colder than 60°F (15.6°C)?
Wash water colder than 60°F (15.6°C)
may not completely
dissolve
the detergent.
Are you using a low speed wash cycle?
Powdered
detergents
may not dissolve
we[[ in a slow-speed
cycle.
For best results,
use
liquid
detergent
for slow-speed
cycles such as Delicate,
Silk, Woo[,
and Handwash.
Stains on load
Did you add detergent
to the dispenser?
For best results, add detergent
to the detergent
compartment.
Do not add detergent
to the
washer
drum.
Did you use enough HE detergent?
Use enough
detergent
to remove
soil and hold it in suspension.
Use only HE detergent.
Follow
the manufacturer's
instructions
to determine
the amount
of detergent
to use.
Is there above average iron (rust) in water?
You may need to install an iron filter.
Did you properly
sort the load?
Sort dark clothes from whites and lights.
Did you unload the washer
promptly?
To avoid transfer of dye, unload
the washer
as soon as it stops.
Did you use a fabric
softener
dispensing ball?
Dispensing
balls will
not operate
correctly
with
this washer.
Add
liquid
fabric
softener to
the fabric
softener
compartment.
Did you use powdered
detergent in a low-speed
cycle?
Consider
using liquid
detergent.
Did you use Rapid Wash on a large load?
For best results, use Rapid Wash for small, lightly soiled loads.
Load is wrinkled
Did you unload the washer promptly?
Unload the washer as soon as it stops.
Did you use the right
cycle for the load being washed?
Use the Delicate
cycle or another
cycle with
a low spin speed to reduce wrinkling.
Did you overload
the washer?
The wash load must be balanced
and not overloaded,
loads should
tumble
freely during
washing.
Gray whites,
dingy colors
Did you properly
sort the load?
Transfer of dye can occur when
mixing
whites
and colors in a load. Sort dark clothes
from whites and lights.
Was the wash temperature
too low?
Use hot or warm washes if safe for the load. Make sure your hot water system is adequate
to provide
a hot water wash.
Did you use enough detergent,
or do you have hard water?
Use more detergent
for washing
heavy soils in cold or hard water.
24
....
...................................................................................................................................................................................................................................................

Publicidad

loading