Publicidad
Idiomas disponibles
Idiomas disponibles
Maintenance
Maintenance regulations
Interval
Maintenance work
▶ Inspect the pressing
tool, rechargeable
battery and battery
charger for externally
visible defects and
damage that could affect
safety.
Regularly
▶ Clean and lubricate the
(before use,
pressing tool.
at the start of
▶ Clean pressing
the working
attachments and check
day)
for defects, particularly
for incipient cracks.
▶ Lubricate the pressing
attachments. → See
user manual for the
pressing attachments in
question.
▶ Have the battery charger
inspected for safety-
related defects or
damage by an
authorised repair shop.
However, this metro-
Every six
logical measurement
months
does not replace any
country-specific
regulations and legis-
lation that might
prescribe further checks
and maintenance work.
After two
years at the
most as per
specific-
ations on the
▶ Have an authorised
service
repair shop check the
sticker or
pressing force and the
when the red
state of wear.
and the
green LEDs
flash
alternately
72057595934256523 © 12-2023
968.403.00.0(03)
Cleaning and lubricating the
Geberit pressing tool
WARNING
Risk of injury from switching
on inadvertently
▶ Remove the rechargeable
battery before starting any
maintenance work on the
pressing tool.
ATTENTION
Damage to the device from moisture
▶ Never clean the pressing tool with
water or other liquids.
1
Push in both release buttons on the
rechargeable battery and pull it out.
2
Clean the roller drive, roller drive
guide and retaining pin of the
pressing tool.
3
Use a brush to remove dirt.
EN
31
Publicidad
