Publicidad
Idiomas disponibles
Idiomas disponibles
Water temperature
Chlorine
concentration
Connection
by the filter pump.
3. Installation of the unit
Fixing and electrical connections
Before connecting and electrical energization, the unit must fix to a wall of plant room via the
attachment holes in each corner, using the supplied screws and plugs. Make sure it is protec-
ted from the weather, avoid direct exposure to sunlight.
The electrical connection must be performed by a qualified electrician and comply with NF C
15-100 (2002 edition).
• The powder supply to the unit:
The system must work at the same time as the filtration pump.
The connection is then made to the filtration pump's contactor via a 4A fuse box.
A chlorinator that is directly connected to a
230 VAC power supply could damage the components of the hydraulic circuit and will not be
covered by the warranty.
(Recall, to set the time of filtration, the commonly used formula is equal to the water tempe-
rature .. 2.
Example: For 28 º C water filtration time will be 14 hours).
Power of salt electrode: connect the cable for this purpose. Correctly tighten the nuts. A badly
tightened connection will result overheating.
Precautions to be taken before the intervention on the unit:
Isolate the electrical system using a separation device such as energy
• Circuit breaker or disconnect switch.
Device to be installed for protection against short circuits or overcurrent
• Type differential switch 30 mA (power to adopt following the installation).
The caliber of the protection device may not exceed 4 A.
lnstallation schema
1
Electrolyzer
2
Electrode
3
Heating
4
Filter
5
Pump
6
Pool
7
Power box
8
Rail DIN power
9
Breaker
10
Contactors
11
Clock
12
Fuse holder 4A
Do not operate when water is colder than15ºC.
Between 0,5 and 2,5 ppm
230 volts-50/60 Hz, P. maxi 100W and must be controlled by the
filter pump.
Publicidad
