Operation - Fermax iLoft VDS Manual De Instalador Y Usuario

iLoft VDS iLoft VDS
Lock Release / Call Guard Unit Button
· Pressing this button whilst communicating with the Entry Panel will activate the lock
release.
· Pressing this button whilst the monitor is on standby will result in a call being made
to the guard unit (where one exists).
Note: If the channel is busy an error tone «BEEP» will sound and auto-start will not
activate, nor will the call to the guard unit.
Auto-Start / Main-Secondary Camera Selection Button
· With the monitor on standby, press this button for 1 second to switch the monitor
on manually. To activate the audio, press the
· With video, hold this button down for 2 seconds to sequentially select between the
main camera and the secondary camera (if there is one).
Note:
- If the channel is busy an error tone «BEEP» will sound and auto-start will not
activate, nor will the call to the guard unit.
- The auto-start function is always used on the main panel except where a call
is received on the secondary panel. Once the conversation is over, auto-start
will activate on the secondary panel for 30 seconds. After this time it will ac-
tivate on the main panel.
F1 and F2: Buttons for Additional Functions.
(Assigned by the installer; see the corresponding chapters).
NOTE: The monitor screen goes on once the call from the panel has ended.

Operation

Pag 20
Opening the Door
When a call is received from the entry panel, you can open the door
at any time, by pressing the
button.
button.