Programming The Monitor; Option 1: From Panel + Monitor; Option 2: From The Monitor - Fermax iLoft VDS Manual De Instalador Y Usuario

iLoft VDS iLoft VDS
PROGRAMMING THE iLOFT MONITOR
The monitor will not function until it has been programmed.

Option 1: From Panel + Monitor

1
1º. With the monitor connected, press the programming button «PROG
seconds (to access this, you must lift up the front cover). A confi rmation tone will sound.
2º. Press the call-to-residence button. Again a confi rmation is made with a different call tone.
Note: The time between steps 1 and 2 must be less than 2 and half minutes.
Option 2: From the Monitor You can program the monitor via the on-screen menu.
1º. Enter in the User menu. Press «Menu» 1 second.
1
¸
1"
2 secs
< 2 min. 30 sec.
Note: If the monitor is not yet programmed, press
MENU
2
User Menu
«Menu» for 1 second, and directly access the
«ADMINISTRATOR Menu», see the next page.
(*)
Function available depending on model.
» for 2
(*)
Page 7