Publicidad
Idiomas disponibles
Idiomas disponibles
EN
9.5.1
REMOVE THE SPRAY TIP
Note :
• Before removing the spray tip, you should turn off
the power switch and remove the power cord plug
from electrical outlet.
• Disconnect water supply to the product.
• ALWAYS point the spray gun in a safe direction,
push the trigger safety lock up and squeeze the
trigger to release retained water pressure.
1.
Pull back and hold the quick-connect collar on the
spray wand.
2.
Remove the spray tip from the spray wand.
9.5.2
CLEAN THE SPRAY TIP
1.
Use a small paper clip to free any foreign material
clogging or restricting the spray tip.
2.
Using a garden hose, flush debris out of spray
tip by back flushing (running the water through
the spray tip backward or from the outside to the
inside).
3.
Reinstall the spray tip to the spray wand.
9.6
RECOMMENDED PUMP CARE
• Regularly using pump protector solution (not
included) can help extend the lifespan of the
product. It aids in the removal of hard water mineral
deposits, lubricates pump seals and pistons, and
prevents freeze damage.
English
• To maintain the best performance of the product,
pump protector should be added to the product after
every use and before long-term storage.
Note: The following steps are typical for adding pump
protector to the product. Always read the specific
instructions provided by the manufacturer of the pump
protector used before starting.
1.
Turn the water tap off and make sure the product
is powered off.
2.
Press the spray gun trigger for approximately 1
minute or until no more water discharges from the
connected accessory.
3.
Disconnect the power cord from the outlet.
4.
Disconnect the hose from the water inlet.
5.
Remove the cap from pump protector bottle and
insert the pump protector spout into the water
inlet.
6.
Turn the water inlet sleeve to secure the
connection.
7.
Squeeze the pump protector bottle to inject
protector fluid into the product.
8.
The procedure is complete when the protector
fluid discharges from the water outlet.
9.7
ADDING LUBRICATING OIL
This product is a professional pressure washer. For
better and longer use, you should add lubricating oil
first after 50 hours' use. After first oil addition, you
only need to add lubricating oil every 200 hours.
Only use the recommended lubricating oil: S15W-40.
1.
Clean the grease on crankcase.
2.
Insert a funnel into the lubricating oil port.
3.
Add the lubricating oil (240-260ml every time) into
the port.
12
WARNING
WARNING
Publicidad
