Publicidad
Idiomas disponibles
Idiomas disponibles
EN
6.2.2
CHECK THE HIGH-PRESSURE HOSE
• If the high-pressure hose is damaged, replace
immediately.
6.2.3
CHECK THE WATER INLET SCREEN
Inspect the inlet screen. Remove debris or replace if
damaged.
6.3
SAFETY INSTRUCTIONS FOR
MAINTENANCE
Read the warning instructions that follow before you
do maintenance on the product.
• Before inspecting, cleaning, or servicing the product,
shut off the product, wait for all moving parts to
stop, disconnect the product from the power supply,
and squeeze the spray gun trigger to release water
pressure. Failure to follow these instructions can
result in serious personal injury or property damage.
• When servicing, use only identical replacement
parts. Use of any other parts could create a hazard
or cause product damage.
• Periodically inspect the entire product for damaged,
missing, or loose parts such as screws, nuts, bolts,
caps, etc. Securely tighten all fasteners and caps
and do not operate this product until all missing or
damaged parts are replaced. Please call customer
service or contact an authorized service center for
assistance.
• Avoid using solvents when cleaning plastic parts.
Most plastics are susceptible to damage from
various types of commercial solvents and may be
damaged by their use. Use clean cloths to remove
dirt, dust, oil, grease, etc.
• Do not at any time let brake fluids, gasoline,
petroleum-based products, penetrating oils, etc.,
come in contact with plastic parts. Chemicals can
damage, weaken, or destroy plastic which could
result in serious personal injury.
• Neglecting regular maintenance decreases the life
cycle of the product and increases the risk of
accidents.
• Special training is necessary for all servicing and
repair work, especially for the safety features on
the product. If not all checks in this operator's
manual are approved after maintenance, speak to
your servicing dealer. We guarantee that there are
professional repairs and servicing available for your
product.
SAVE THESE INSTRUCTIONS
WARNING
English
7
ASSEMBLY
This section describes how to assemble and adjust the
product.
CAREFULLY READ AND UNDERSTAND THE
SAFETY CHAPTER AND THE ASSEMBLY
INSTRUCTIONS BEFORE YOU ASSEMBLE THE
PRODUCT.
7.1
INSTALL THE UPPER HANDLE
1.
Press and hold the handle lock buttons on the
upper handle.
2.
Slide the upper handle into the lower handle until
the lock buttons pass through the locking slot to
secure the upper handle in place.
7.2
INSTALL THE FRONT PANEL & SPRAY
TIPS & TURBO NOZZLE
1.
Insert the spray tips and turbo nozzle into the
front panel.
2.
Mount the front panel onto the rear side of the
upper handle.
6
WARNING
Publicidad
