Descargar Imprimir esta página

GreenWorks GPW3100C Manual Del Operador página 9

Publicidad

Idiomas disponibles

Idiomas disponibles

3.
Release the quick-connect collar to lock the spray
tip in place.
Note: Tug on the spray tip to make sure it is secured in
place.
8
OPERATION
This section describes how to operate the product.
WARNING
CAREFULLY READ AND UNDERSTAND
THE SAFETY CHAPTER AND OPERATION
INSTRUCTIONS BEFORE YOU OPERATE THE
PRODUCT.
8.1
BEFORE YOU START
8.1.1
PREPARE A DRIP LOOP
A drip loop is an important safety measure that
prevents water from dripping into the electrical outlet.
To set up a drip loop, use an object to elevate the part
of the cable closest to the outlet, in order to create a
downward droop. This droop will help ensure that any
water running down the cable is directed away from
the outlet. Use a cable clip to secure drip loop in place.
WARNING
Failure to prepare a drip loop can result in serious
injury and/or property damage.
English
Ensure that the extension cord remains clear of the
working area. Position the cord in a manner that
prevents it from getting entangled with lumber, tools,
or other obstructions while operating a product.
Failure to do so may result in severe personal injury
or death.
8.1.2
ADD DETERGENT
Only use soaps/detergents that are specifically
designed for pressure washers. Do not use
household detergents, acid, alkaline, bleaches ,
solvents, flammable materials, or industrial-grade
solutions, which can damage the product.
Note:
• Use a funnel to prevent spilling detergent. Clean
and dry any spilled detergent to prevent accidental
slips or falls.
• Soap/detergent can only be applied with this product
when the black soap spray tip is installed.
1.
Ensure the product is on a flat surface.
2.
Remove cap from detergent tank and fill the tank
with detergent solution.
3.
Close the cap.
8.2
START THE PRODUCT
The product should be connected to a power
supply that is 120V, 60 Hz, AC only (household). A
considerable voltage drop will cause a loss of power
and the motor will overheat.
DO NOT start the product without the water supply
connected and turned on, as this will harm the pump.
9
WARNING
CAUTION
CAUTION
CAUTION
EN

Publicidad

loading