Olimpia splendid Bi2 WALL AR 1000 Instrucciones Para El Uso Y El Mantenimiento página 42

it will cause electrical shock fire.
10. Use the specified cable and connect tightly and clamp the cable so
that no external force will be acted on the terminal.
If connection or fixing is not perfect, it will cause heat-up or fire at the
connection.
11. Wiring routing must be properly arranged so that control board cover
is fixed properly.
If control board cover is not fixed perfectly, it will cause heat-up at
connection point of terminal, fire or electrical shock.
12. If the supply cord is damaged, it must be replaced by the manufacture
or its service agent or a similarly qualified person in order to avoid a
hazard.
13. An all-pole disconnection switch having a contact separation of at
least 3mm in all poles should be connected in fixed wiring.
14. The cold water temperature inside the unit must not be lower than 3°C,
while hot water must not exceed 70°C. Water in the unit must clean,
air quality must meet to the standard of PH=6. 5 and 7. 5.
15. Do not disconnect the electric power supply manually when the ap-
pliance is running, since malfunctioning could occur.
16. Ask your dealer for installation of the air conditioner.
Incomplete installation performed by yourself may result in a water
leakage, electric shock, and fire.
17. Ask your dealer for improvement, repair, and maintenance.
Incomplete improvement, repair, and maintenance may result in a
water leakage, electric shock, and fire.
18. In the event of operating anomalies (e.g. strange noise, bad odour,
smoke, abnormal temperature rise, electric dispersions, etc.), switch
the appliance off immediately and disconnect the electric power supply.
For repair work contact solely the technical service centres author-
ised by the manufacturer and ask for original spare parts to be used.
Failure to do this can affect the safety of the appliance.
19. Do not wet the indoor unit and the remote control.
Short circuits or fires may occur.
20. If a fuse blows, do not replace it with one that has a different amperage
and do not use cables of any type.
Use of wire or copper wire may cause the unit to break down or cause
a fire.
21. It is not good for your health to expose your body to the air flow for
a long time.
22. Do not insert fingers, bars or other objects inside the air input and
output grilles. When the fan is rotating at high speed, it will cause
EN - 6