Olimpia splendid Bi2 WALL AR 1000 Instrucciones Para El Uso Y El Mantenimiento página 63

b. After 20 seconds of operation of the fan motor, the circuit board tries again to
check the feedback received from the motor for 10 seconds.
c. If the error persists for 5 consecutive times, the motor is switched off and the green
led starts blinking 2 times.
To restore the system, the circuit board must be switched off and on again.
9.2 - SYMPTOMS THAT DO NOT INDICATE APPLIANCE MALFUNCTIONING
White mist escaping from the appliance
If the cooling function is started in a room with high humidity level an the inside of the
appliance is very contaminated, the distribution of the temperature is not regular. In this
case, it will be necessary to clean the inside of the appliance.
Contact your dealer for additional details regarding cleaning the appliance.
This operation requires a qualified professional.
Noise level during operation
a. The appliance emits a low and continuous noise, like hissing, in cooling mode or when stopping.
This noise is caused by operation of the drain pump (optional accessory).
b. The appliance emits a squealing noise, like a squeak, when the system stops after operation
in heating mode.
This noise is caused by the expansion and contraction of the plastic parts due to temperature changes.
Dust escaping from the appliance
a. This occurs when the appliance is used for the first time after a long period of time and
depends on the accumulation of dust inside the appliance
The appliance gives off odours
a. The appliance can absorb the odour of rooms, furniture, cigarettes, etc. and return them
to the environment.
9.3 - INCONVENIENCES AND POSSIBLE REMEDIES
Consult the following points before requesting assistance or repairs.
MALFUNCTIONING
The appliance does not start
The air circulates regularly, but
cooling is insufficient
CAUSE
Electric current failure
Switch is off
Switch fuse probably blown
Remote control batteries dis-
charged or remote control broken
Temperature not set correctly
WHAT MUST BE DONE?
Wait for the electric current to
reset
Switch the unit on
Replace the fuse
Replace the batteries or examine
the remote control
Set the correct temperature
Bi2 WALL AR 1000/1200/1400
>>>>>
EN - 27