Publicidad
Idiomas disponibles
Idiomas disponibles
Operation
■
Never allow the pump to run against a closed
pressure line.
■
When using in shafts, make sure the size is
adequate.
■
Always cover the shaft with a secure foot-
plate.
6 OPERATION
6.1
Switching the pump on
IMPORTANT! Danger of damage to the
pump! The pump must not draw in any solid ma-
terial. Sand and other abrasive materials in the
pumped medium will destroy the pump.
■
Ensure that no solids can enter the pumped
medium.
NOTE Use a suitable plate to ensure stable
standing of the pump on muddy, sandy or stony
ground.
1. Completely unwind mains cable (1).
2. Ensure that electrical plug connections are
located in the area safe from flooding.
3. Change the clamping position and set the
switching points of float switch (5) individually.
4. Clamp cable of float switch to the pump
housing. Recommended cable length on the
float switch approx. 120 mm.
5. Slowly immerse the pump in the pumped me-
dium, holding the pump at a slight angle so
that any trapped air can escape.
6. Vent pump DRAIN 10000 INOX / 15000
INOX / DRAIN 20000 HD at the vent.
7. Insert the mains plug into the power socket.
The immersion pump switches on automatically
using the float switch when a specific water level
has been reached, and switches off again if the
water drops below the switch-off height.
6.2
Switching the pump off
1. Remove the mains plug from the plug socket.
7 MAINTENANCE AND CARE
DANGER! Danger of electric shock!
There is a risk of electric shock when working on
the pump.
■
Disconnect the mains plug before starting
any fault remedying work.
■
Faults in the electrical system must be recti-
fied by a qualified electrician.
467771_k
7.1
Cleaning the pump
NOTE After conveying swimming pool water
containing chlorine or fluids that leave residues,
the pump must be flushed out with clear water.
1. Clean the suction slots on the suction foot
with clear water, if necessary.
8 HELP IN CASE OF MALFUNCTION
DANGER! Danger of electric shock!
There is a risk of electric shock when working on
the pump.
■
Disconnect the mains plug before starting
any fault remedying work.
■
Faults in the electrical system must be recti-
fied by a qualified electrician.
NOTE In the event of faults that you cannot
rectify, please contact our Customer Service de-
partment.
Malfunction
Possible
cause
Engine does
Impeller
not start.
blocked.
Thermal pro-
tection switch
has switched
off.
No mains
power.
Float switch
does not trip
when the wa-
ter level rises.
Remedy
Remove dirt
from the suction
area. Clean with
a suitable tool
through the
opening on the
back of the mo-
tor housing.
Wait until the
thermal protec-
tion switches on
the pump again.
Take note of the
maximum tem-
perature of the
conveying medi-
um. Have the
pump inspected.
Check the fus-
es, have the
power supply
checked by a
qualified electri-
cian.
Send the pump
to an AL-KO
service facility.
17
Publicidad
