Installation; Required Tools; Initial Conditions And Checks; Securing The Elements - Erreka VIVO-M201 Manual Del Instalador

INSTALLATION

1

REQUIRED TOOLS

Set of screwdrivers
Marker pencil
Tape measure
2

INITIAL CONDITIONS AND CHECKS

Initial installation conditions
 Ensure the operator is correctly installed in the
gate.
Environmental conditions
 This device is not suitable for installation in
inflammable or explosive environments.
Electrical power supply installation

Ensure the direct current connection and
installation fulfil the following requirements:
• The nominal voltage of the installation must
coincide with that of the control board.
• The installation must be able to support the
power consumed by all the automatic key
devices.
• The installation must be earthed.
3

SECURING THE ELEMENTS

1 Choose a location for the control board, taking as a
reference the figure shown in "Elements of the
complete installation (swing gate)" on page 39.

The height from the ground must be
sufficient as to be out of the reach of children.

The attachment surface must resist the
weight of the control board.
2 Make two holes and attach the control board with
appropriate screws.
3 Attach the other elements of the installation in line
with the corresponding instructions.
Electrical drill and broaches

Use the electrical drill in line with the user
manual.
 An earthed power supply of 230Vac, 50Hz
(VIVO-M201) or 125Vac, 60Hz (VIVO-M201M) is
required.
 Check that the admissible environmental
temperature range for the control board is
suitable for the location.
• The electrical installation must comply with
low voltage regulations.
• The installation elements must be properly
secured and in a good state of conservation.
• The direct connection point must be high
enough to be out of the reach of children.

If the electrical installation does not comply
with the foregoing requirements, repair before
installing the automatic key device.
4 Position the ducts for the cable, securing them firmly
using appropriate means.

If pushbuttons are installed to operate the
facility, we recommend installing them out of
the reach of children (minimum recommended
height 1.6 m).
English
Control board VIVO-M201(M)
43