Erreka VIVO-M201 Manual Del Instalador página 49

Peripheral connections
ST1
FT1
ST2
FT2
SMF
Signal light card (EPS1-001)
ANT
Antenna connector
R.E.
Plug-in receiver
A.T. (ST1) Key device
S.EXT (FT1) Exterior safety device (photocell or
mechanical strip)
A.P. (ST2) Pedestrian operation device
S.INT (FT2) Interior safety device (photocell or
mechanical strip)

Fig. 4 Peripheral connections
FCA2 COM FCC2
P1 P2 P3 P4 P5 P6 P15 P14 P16 P7 P8
ST1 FT1 ST2 FT2 FCA1 FCC1
VIVO-M201: 230Vac
VIVO-M201M: 125Vac
Check the accessory instructions to carry out the connections.
SCA
G4 G5
P11 P12 P22 P23 G7 G8 G9 G10
Courtesy
24Vac Lamp. MOTOR2 (G2-G1-COM)
STOP LOCK
Light
STOP Emergency stop pushbutton (normally closed)
EC
Electrolock (17Vdc)
AUX Output (24Vac, 0.35A)
LG
Garage light (courtesy light)
VIVO-M201: 230Vac, max. 2,300W resistive)
VIVO-M201M: 125Vac, max. 1,250W resistive)
DEST Flashing light (max. 40W resistive)
VIVO-M201: 230Vac
VIVO-M201M: 125Vac
SW1
Main switch
INSTALLATION
G6 G1 G2 G3
N L
POWER
MOTOR1 (G2-G1-COM)
(resistive)
VIVO-M201: 230Vac
VIVO-M201M: 125Vac
VIVO-M201: max 2.300W
VIVO-M201M: max 1.250W
(resistive)
Control board VIVO-M201(M)
P169Z
45