EHEIM LOOPpro 12000 Manual De Instrucciones página 14

English
Fitting the outlet funnel (⌦C)
1. Check the correct fit of the seal ① in the outlet funnel ②.
2. Slip the sealing ring ③ onto the outlet funnel.
3. Insert the outlet funnel from the inside through the opening in the filter container.
4. Fasten the outlet funnel with the union nut ④.
Fitting the UVC clarifier (⌦D/E)
1. Slip the sealing washer ② onto the thread of the UVC clarifier.
2. Insert the UVC clarifier through the opening in the filter container.
3. Fasten the UVC clarifier with the union nut ①.
4. Insert the screw ④ with the O-ring ⑤ from the inside through the hole in the mounting bracket of the
UVC clarifier.
5. Screw the UVC clarifier tight with the nut ⑦ and the washer ⑥.
Fitting the hose connecting piece (⌦F)
1. Slide the union nut ③ onto the hose connecting piece ②.
2. Insert the seal ① into the union nut.
3. Screw the hose connecting piece onto the UVC clarifier with the union nut.
Inserting the filter (⌦G)
1. Check that the seal ⑤ is correctly seated in the pre-filter tray ③.
2. Insert the filter in the filter housing in the following order:
① Filter insert with filter foams
② Bioballs
Make sure that there are no bioballs on the outlet funnel (⌦E)!
③ Prefilter tub
④ Blue prefilter mat
3. Seal the filter container with the filter container cover.
Installing the pump connection (⌦J)
1. Connect the spiral hose of the pump to the hose connecting piece on the UVC clarifier.
We recommend fastening the hoses with hose clamps.
Connecting the outlet hose (optional)
If required, an outlet hose (Ø 2") can be fitted onto the outlet funnel from the outside.
14