EHEIM LOOPpro 12000 Manual De Instrucciones página 16

English
Cleaning
1. Remove the mains plugs of the pump and the UVC clarifier.
2. Take off the filter container cover (⌦A).
3. Remove all filters from the housing (⌦G).
4. Clean all filters under cold, running water.
5. Clean the inside of the filter container with a water jet.
6. Put the filters back in reverse order and close the filter container (⌦G).
Replacing the filter foams
Recommended maintenance
After every second or third cleaning, the filter foams must be replaced. In order to ensure the bacterio-
logical functioning of the filter, only two foams at a time may be replaced at delayed intervals.
1. Turn the receptacle ① of the filter foam ② to the right (⌦I➊).
2. Pull the filter foam downwards, and out of the filter insert (⌦I➋).
3. Remove the filter foam from the receptacle.
4. Fit the new filter foam onto the receptacle.
5. Install the filter foam again in reverse order.
Clearing faults
DANGER! Electric shock!
▶ Before clearing faults, remove the mains plug.
Fault
Filter capacity decreases
For other faults, please contact EHEIM Service.
Technical data
LOOPpro
Type
Pump
UVC clarifier
Dimensions with UVC clarifier (L × W × H)
Water outlet
Media temperature
The technical data of the pump and the UVC clarifier are found in the associated operating manuals.
Possible cause
Filters are soiled
Pump is soiled
6000
5215
PLAY1500
CLEARUVC-9
525 × 435 × 290 mm
16
Remedy
▶ Clean the filter
▶ Clean the filter housing of the
pump (see pump operating
manual)
8000
5216
FLOW2500
CLEARUVC-11
525 × 435 × 380 mm
2"
+4°C – +35°C
12000
5214
FLOW3500
CLEARUVC-18
525 × 435 × 380 mm