EHEIM LOOPpro 12000 Manual De Instrucciones página 15

English
Operation
DANGER! Electric shock!
▶ When the UVC clarifier is fitted, the device's safety distance from the water must be at least 2 m.
DANGER!
▶ Heed the operating manual for the UVC clarifier and the pump, especially the chapters on safety,
commissioning and operation!
1. Place the filter on the pond bank (⌦J).
2. Place the pump on a solid surface as horizontal as possible in the pond so that the filter housing
of the pump is covered by at least 20 cm of water. Pay attention to the maximum pond depth (see
Technical data).
Switching on the pump and UVC clarifier
1. Insert the respective mains plug into the mains socket.
Attention: The pump starts immediately!
Switching off the pump and UVC clarifier
1. Remove the respective mains plug from the mains socket.
Maintenance
DANGER! Electric shock!
▶ Before all maintenance work, disconnect the mains plugs of the pump and the UVC clarifier.
DANGER!
▶ Heed the operating manual for the UVC clarifier and the pump, especially the chapters on safety and
maintenance.
CAUTION! Material damage.
▶ Do not use hard objects or aggressive cleaning agents for cleaning.
The following sections describe maintenance work necessary for optimum and fault-free operation.
Regular maintenance prolongs the service life and assures functionality of the through-flow filter over a
long period.
Contamination indicator (⌦H)
The through-flow filter has a contamination indicator. Check the contamination indicator approximately every 4
weeks. To do so, proceed as follows:
1. Take off the filter container cover (⌦A).
2. Remove the prefilter tub with the prefilter from the filter container.
3. Check whether the water level is at 50% or 75%. If the level of contamination is 75%, the through-
flow filter must be cleaned.
For a correct indication of the degree of contamination, the pump must be switched on.
15