Trix H0 Ce 6/8 II Serie Manual De Instrucciones página 11

Safety Notes
• This locomotive is only to be used with the operating
system it is designed for.
• Analog max. 15 volts DC, digital max. 22 volts AC.
• This locomotive must never be supplied with power from
more than one power pack.
• Please make note of the safety notes in the instructions
for your operating system.
• The feeder track must be equipped to prevent inter-
ference with radio and television reception, when the
locomotive is to be run in conventional operation. The
611 655 interference suppression set is to be used for this
purpose. The interference suppression set is not suitable
for digital operation.
• WARNING! Sharp edges and points required for operation.
• Do not expose the model to direct sunlight, extreme
changes in temperature, or high humidity.
• The LEDs in this item correspond to Laser Class 1 accor-
ding to Standard EN 60825-1.
• This item has a decoder with an mtc21 interface. The
decoder outputs included on it control different auxiliary
functions. Correct operation of these auxiliary functions
is guaranteed only if you use the Märklin/Trixdecoder
specific to the item. The SW configuration on the decoder
is specially calibrated to that item. Using other compo-
nents may cause damage!
All manuals and user guides at all-guides.com
Important Notes
• The operating instructions and the packaging are a com-
• Please see your authorized Trix dealer for repairs or
• The warranty card included with this product specifies
• Disposing: www.maerklin.com/en/imprint.html
• The full range of functions is only available under DCC
• Built-in headlights that change over with the direction of
• Only the train control functions and headlight changeover
• The locomotive cannot be switched to operation from
• Minimum radius for operation is 360 mm/14-3/16".
Multi-Protocol Operation
Analog Operation
This decoder can also be operated on analog layouts or ar-
eas of track that are analog. The decoder recognizes alter-
nating current (DC) and automatically adapts to the analog
track voltage. All functions that were set under mfx or DCC
for analog operation are active (see Digital Operation).
ponent part of the product and must therefore be kept as
well as transferred along with the product to others.
spare parts.
the warranty conditions.
and mfx.
travel. They can be turned on and off in digital operation.
feature are available in analog operation.
catenary.
11