Descargar Imprimir esta página

Trix H0 Ce 6/8 II Serie Manual De Instrucciones página 12

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 42
Digital Operation
The decoders are multi-protocol decoders. These decoders
can be used under the following digital protocols: mfx, DCC
or MM.
Address set at the factory: DCC 03 / MM 68 (69)
The digital protocol with the most possibilities is the highest
order digital protocol. The sequence of digital protocols in
descending order is:
Priority 1: mfx
Priority 2: DCC
Priority 3: MM
Note: If two or more digital protocols are recognized in the
track, the decoder automatically takes on the highest value
digital protocol.For example, if mfx & DCC are recognized,
the mfx digital protocol is taken on by the decoder. Individual
protocols can be deactivated with Parameter CV 50.
Note: Please note that not all functions are possible in all
digital protocols. Several settings for functions, which are
supposed to be active in analog operation, can be done
under mfx and DCC.
Notes on digital operation
• The operating instructions for your central unit will give
you exact procedures for setting the different parame-
ters.
• The setting done at the factory does not permit operation
with opposite polarity DC power in the braking block.
If you want this characteristic, you must do without
conventional DC power operation (CV 29/Bit 2 = 0).
12
All manuals and user guides at all-guides.com
mfx Protocol
Addresses
• No address is required; each decoder is given a one-
• The decoder automatically registers itself on a Central
• Name set at the factory: Ce 6/8 II 14282
Programming
• The characteristics can be programmed using the
• All of the Configuration Variables (CV) can be read and
• The programming can be done either on the main track or
• The default settings (factory settings) can be produced
• Function mapping: Functions can be assigned to
time, unique identifier (UID).
Station or a Mobile Station with its UID.
graphic screen on the Central Station or also partially
with the Mobile Station.
programmed repeatedly.
the programming track.
repeatedly.
any of the function buttons with the help of the
60212 Central Station (with limitations) and with the
60213/60214/60215/60216/60226 Central Station (See help
section in the Central Station).

Publicidad

loading

Este manual también es adecuado para:

22967