Husqvarna PG 510 Manual Del Usuario página 10

2. Hold the handlebar to keep the frame stable and lift
the support foot out and up.
3. Select the applicable position for the operation and
tighten the lock knob. The bottom hole increases the
grinding pressure and the height of the handlebar.
The top hole decreases the grinding pressure and
the handlebar.
Handle heights
Hole position Handle height, mm
Top 765
Center 870
Lower 960
Diamond tools
There are many types of diamond tools for the
product. Speak to your approved service center or
go to www.husqvarnaconstruction.com to select correct
diamond tool.
10
Installation of the diamond tools
The installation of the diamond tools on the tool plate
has effect on the performance of the product. The
diamond tool type together with the number of segments
on the diamond tool is important.
Use metal bond diamond tools with 2 segments for
usual grind operations, to make the surface level or light
removal.
Use metal bond diamond tools with 1 diamond segment
to increase the diamond tool pressure. This installation
is for heavy removal with much force.
For the heaviest removal, we recommend to use tools
that only run in one direction with PCD diamond tops.
Note:
T-Rex tools are made to run only in one
direction.
Metal bond diamond tools
Note:
We recommend 3 tools with 1 segment on each
™
EZchange holder when you remove surface or usual
concrete.
™
• Use EZchange holder to attach metal bonded
diamond tools.
™
• An EZchange holder with half set.
1146 - 003 - 21.03.2024