Husqvarna PG 510 Manual Del Usuario página 16

• The product restarts after approximately a minute,
when the temperature of the motor is decreased to
usual level.
• Make sure that the extension cables are not too
short.
The product stops during startup
Correct voltage supply is necessary for a good motor
performance. Too long extension cables and/or a too
To set the product in transport position
Put some type of protection on the product during
transportation. The protection keeps natural elements
such as rain and snow away from the product.
The product can be divided into 2 components. This
makes the transportation easier.
Always move the product with the lifting eye and the
handlebar.
1. Disconnect the motor cable from the electric
enclosure (A).
16
Transportation and storage
A
small gauge decreases the power of the motor during
operation.
• If the motor overloads, the overload lamp comes on.
Wait for 2 minutes and try again. When this does not
help, speak to an approved service workshop.
• Make sure that the extension cables are not too
long.
2. Pull out the lock pins (A) and remove the lock bolts
(B) on each side of the grinding head.
B
3. Remove the wheel chassis from the grinding head.
A
1146 - 003 - 21.03.2024