Husqvarna PG 510 Manual Del Usuario página 7

ON/OFF switch
The ON/OFF switch is used to start and stop the
product.
To do a check of the ON/OFF switch
1. Turn the emergency stop button clockwise to make
sure that emergency stop button is disengaged.
2. Push down the handle lightly to lift the grinding
head from the surface, approximately 1 mm. This
decreases the pressure against the surface. Do not
lift the grinding head fully from the surface.
1146 - 003 - 21.03.2024
3. Turn the ON/OFF switch to 1 to start the product.
4. Wait for 5 seconds, this is to let the product operate
at the idle speed.
5. Turn the ON/OFF switch to 0 to stop the product.
Emergency stop
The emergency stop is used to quickly stop the motor.
The emergency stop at the product breaks the mains
power supply.
7