Husqvarna PG 510 Manual Del Usuario página 14

2. Keep the tool plate against the surface. Make sure
that the tool plate does not rotate before you lift up
the front.
3. Pull out the power plug.
To connect a dust extractor
Use a Husqvarna dust extractor system.
1. Connect the dust extractor to the product. Use a 50
mm (2 inch) hose.
Introduction
WARNING:
maintenance, you must read and
understand the safety chapter.
For all servicing and repair work on the product, special
training is necessary. We guarantee the availability of
professional repairs and servicing. If your dealer is not
a service agent, speak to them for information about the
nearest service agent.
For more detailed information, refer to
www.husqvarnaconstruction.com.
Daily maintenance
Daily maintenance means that you clean the product.
Also that you do a check of the electrical supply, the
brush strip and the grind holder.
14
Maintenance
Before you do
2. Make sure that the filters in the dust extractor are
clean and not damaged. Monitor the dust during the
operation.
To clean the product
CAUTION:
decreases the performance of the product
and can cause the motor to become too hot.
• Always pull out the plug from the mains outlet before
you clean, do maintenance or assemble the product.
• Always clean all the equipment at the end of the
work day. Do not use a high pressure washer to
clean the product.
• Always do the maintenance on level ground.
• Remove blockage from all air openings. The product
must always have sufficiently cool temperature.
To do a check of the electrical supply
WARNING:
cables. A damaged cable can cause serious
injury or death.
A blocked air intake
Do not use damaged
1146 - 003 - 21.03.2024