Descargar Imprimir esta página

Thermador T36IT70CNS/01 Instrucciones De Instalación página 11

Congelador independiente (3 puertas)
Ocultar thumbs Ver también para T36IT70CNS/01:

Publicidad

Idiomas disponibles

Idiomas disponibles

Required accessories
1.
Supplied
accessories
Installation
instructions
Operating
instructions
Installation
kit
and
2.
Optional
accessories
Basic Combination
Side-by-Side
Sealing
kit
"BSEALKIT10"
For permanent
connection
of two individual appliances,
e. g. Freezer next to Refrigerator.
Extreme
Combination
Side-by-Side
Heating
kit
"XH EATKIT10"
a) If the gap between
the appliances
is tess than
6" (160 mm).
Extra long finger
protection
part
Panel unification
part "FPCONNTSIO"
(Metal strip)
For connection
of two furniture doors.
3.
Other required accessories
from specialist
outlets
Ice maker
installation
kit 1/4" OD copper
line
For connecting
appliances
which require water, e.g. for
an ice maker.
[_
Maximum outer diameter of the water pipe
(without fittings):
_3/32"
(10 mm).
4.
Tools
Cordless
screwdriver
T20
Torx screwdriver
T20
Torx bit T20 + magnetic
holder
5/_¢,, (8 ram) hex nut driver
Wood drills in different sizes
Open end wrench 1/2"(SW 13 mm)
Multigrip pliers
Adjustable
wrench
tools
Cutter with adjustable
blade
Metal tape measure
Square
Spirit level length 2' (60 cm) and 4' (1,2 m)
Marking out level, length at least 4' (1.2 m) for
individual appliances
or 7' (2.0 m) for Side by Side
installation
5.
Other
Stepladder
Dolly, hand truck
Hammer drill for drilling holes in watt or floor
Bits according
suitable for material and in different
sizes
Wooden
beam (cross section min. 3" x 4" (75 cm x
100 cm) as an alternative titt protection,
length
according
to the width of the installation
cavity
Wooden
screws in different sizes
Thin (max. _/_6" (1.5 mm)), suitable material to
protect the floor from damage
(e.g. tino)
Suitable material for covering
and protecting
furniture (e.g. protective
sheets)
Adhesive tape
11

Publicidad

loading