Graef CM8002 Manual De Instrucciones página 23

UNPACKING
When unpacking the unit, proceed as follows:
Remove the unit from the box.
●
Remove the packaging parts.
●
Remove any stickers on the unit. Do not remove the type plate!
●
DISPOSAL OF THE PACKAGING
The packaging protects the unit against transport damage. The packaging materials are select-
ed according to the environmental compatibility and disposal-related aspects and can there-
fore be recycled.
The return of packaging into the material cycle saves raw material and reduces the waste vol-
ume. Dispose of the packaging material no longer needed at collection points for the "Green
Dot" recycling system (in Germany).
DISPOSAL OF THE UNIT
At the end of its service life, this product cannot be disposed of in normal domestic waste. The
symbol on the product and in the operating instructions point out to this fact. Reuse the materials
according to their marking. With the reuse, recycling or other forms of recycling of old equip-
ment, you make an important contribution to the protection of our environment. Please ask your
municipal administration for the disposal point.
REQUIREMENTS ON THE INSTALLATION LOCATION
For safe and fault free operation of the unit, the following requirements of the installation location
have to be met:
The unit has to be placed on a solid, flat, horizontal, and non-slipping surface with a sufficient
●
weight-carrying capacity.
Make sure that the unit cannot topple over.
●
Choose the location in such a way that children cannot reach the supply line of the unit.
●
Do not place the appliance on hot surfaces, such as hotplates, or near them.
●
Never use the unit in the open, and store in a dry location.
●
The unit is not designed for installation in a wall or a built-in cupboard.
●
Do not set up the unit in a hot, wet or moist environment.
●
The socket has to be easily accessible so that the power cable can be removed easily in
●
case of emergency.
ELECTRICAL CONNECTION
For safe and fault-free operation of the unit, the following requirements have to be met during
the electrical connection:
Before connecting the unit, compare the connecting data (voltage and frequency) on the
●
type plate with those of your energy network. These details must correspond so that no dam-
age occurs to the unit. In case of uncertainty, contact a qualified electrician.
DE
EN
FR
NL
IT
ES
DK
SE
NO
PL
UKR
HU
23