Fuel Safety - Maruyama MCV31T Manual Del Propietario U Operador

CHAIN SAW SAFETY
1 Make sure the Chain Saw is correctly assembled as instructed in the Assembly section of this manual.
2 Before each use, inspect the Chain Saw, replace damaged parts, and check for fuel leaks. Make sure all
fasteners are in place and tightened securely.
3 Maintain the Chain Saw in accordance with the recommended maintenance intervals and procedures
detailed in the "Saw chain Maintenance" and "Regular Maintenance".
4 Use the correct accessories. Never use replacement parts that are not approved by Maruyama.
5 Shut off the engine before performing maintenance or working on the machine.
6 If running problems or excessive vibration occur, stop immediately and inspect the unit for the cause. If
servicing dealer for repair.
7 Never modify a chain saw in any way.

FUEL SAFETY

1 Gasoline is highly flammable and must be handled and stored carefully. Use a
container approved for storing gasoline and/or fuel/oil mixture.
2 Mix and pour fuel outdoors and where there are no sparks or flames.
3 Do not smoke near fuel storage containers or the Chain Saw. Do not smoke
while operating the Chain Saw.
4 Do not overfill the fuel tank. Stop filling 1/4-1/2inch (6mm-13mm) from the top
of the tank.
5 Wipe up any spilled fuel before starting the engine.
6 Move the Chain Saw at least 10feet (3m) away from the fueling location before
starting the engine.
7 Do not remove the fuel tank cap while the engine is running or immediately
after stopping the engine.
8 Allow the engine to cool before refueling.
9 Empty the fuel tank before storing the Chain Saw. Fuel should be emptied after
each use as fuel remaining in the tank may leak during storage.
10 Store both fuel and the Chain Saw away from open flame, sparks and
excessive heat. Make sure fuel vapors cannot reach sparks or open flames
from heaters, furnaces, electric motors, etc.
— US-14 —
WIPE UP ANY FUEL SPILLAGE
Fueling location
10 Feet
Min. 3 m
Starting the
engine