Cleaning And Sanitizing Procedures - Bras AB Manual De Instrucciones

EN GLIS H
A B - B S
5. 3 CLEANING AND SANITIZING
PROCEDURES
Cleaning and sanitizing of the dispenser are recommended to
guarantee the conservation of the best product taste and the
highest unit efficiency. This section is a procedural guideline
only and is subject to the requirements of the local Health
Authorities. Prior to the disassembly and cleaning, the machine
must be emptied of product.
5. 3. 1 DISASSEMBLY
ATTENTION
Before any disassembly and/or cleaning procedure make
sure that the dispenser is disconnected from its power
source by unplugging it or switching off the 2-pole wall
breaker.
1
Remove cover from the bowl.
2
BS lines: remove pump assembly from its bowl location by
turning (1) clocwise and lifting it up (2) (see figure 4).
Dismantle spray tube and L-shaped tube. Take impeller and
bearing pin away from pump housing by removing the retaining
pin.
3
AB - BS2M line: remove stirrer by lifting up.
4
Remove the empty bowl by lifting its faucet side up and off
cooling dome.
5
Remove the bowl gasket.
6
See 5.3.2 FAUCET DISASSEMBLY paragraph.
7
Slide drip tray out and empty it.
5. 3. 2 FAUCET DISASSEMBLY
5. 3. 2. 1 BS LINES WITH PINCH TUBE
FAUCET
1
Push (1) the dispensing handle and remove (2) the pinch
figure 3
tube from its vertical seat in the bowl bottom (see figure 4).
2
Take the bowl away from the machine and turn it upside
down. Pull (1) the tab release lever and at the same time, turn
(2) to the left (counterclockwise) the faucet body till it gets free,
together with faucet cover, from the bowl (see figure 5).
5. 3. 2. 3 BS LINES WITH GRAVITY
FAUCET
1
Extract (1) the piston and then remove (2-3) the faucet
handle (see figure 6).
2
Take the bowl away from the machine and turn it upside
12
figure 4
figure 5
figure 6