Publicidad
Idiomas disponibles
Idiomas disponibles
Installation
Water Supply and Drain Requirements
WATER SUPPLY
Prepare water supply line and drain before installation of
your ice machine. Installation requires a 1/4" ID copper cold
water line and compression fitting (not supplied). The ice
machine is supplied with a drain hose for gravity draining.
The optional drain pump must be purchased if a gravity
drain is not possible. Both drain methods require routing to
an open site drain. Do not connect directly to drain line as
bacteria from drain line may contaminate the ice machine.
The included water filter is designed to inhibit scale
formation, filter sediment, and remove chlorine odor and
taste. The life expectancy of the water filter is 6 months
during normal usage. The ice machine control board will
monitor water usage and indicate when replacement is
required.
WATER INLET LINES
Follow these guidelines to install water inlet lines:
• Plumbing must conform to state and local codes.
• Do not connect the ice machine to a hot water supply.
Be sure all hot water restrictors installed for other
equipment are working. (Check valves on sink faucets,
dishwashers, etc.)
• If water pressure exceeds the maximum recommended
pressure (80 psi - 55 bar), obtain a water pressure
regulator from your Manitowoc distributor.
• Install a water shut-off valve for the ice making water
lines.
• Insulate the water inlet line to prevent condensation.
DRAIN PUMP OPTION
Disconnect power to ice machine before proceeding.
1. Remove top cover screws and slide cover off. Remove
back panel screws and lift panel off.
2. Assemble the outlet tube and vent tube to the drain
pump.
3. Plug the drain pump's wire assembly into the ice
machine's wire assembly. Slide drain pump into cavity.
4. Swap out existing Bin Drain Tube for Bin Drain Tube
packaged with drain pump.
5. Route the vent tube and outlet tube.
6. Reassemble ice machine.
NOTE: See instructions packaged with drain pump for details.
Upon activation, be sure to check all connections for water
leakage.
14
DRAIN CONNECTIONS
Follow these guidelines when installing drain lines to prevent
drain water from flowing back into the ice machine and
storage bin:
• Drain lines must have a 1.5 inch drop per 5 feet of run
(2.5 cm per meter), and must not create traps.
• The floor drain must be large enough to accommodate
drainage from all drains.
• Drain pump discharge line must terminate at an open site
drain.
• Maximum rise - 12 feet (3.7 m)
• Maximum run - 100 feet (30.5 m)
Approximate Height of Ice Machine Drain
Leg Levelers
Installation with Leg Option
WATER SUPPLY AND DRAIN LINE SIZING/CONNECTIONS
Water
Location
Temperature
Ice
35°F (1.6°C)
Making
Min.
Water
90°F (32.2°C)
Inlet
Max.
Ice
Making
---
Bin Drain
Drain
---
Pump
Part Number 0000017452 Rev 00 06/22
3" (76 mm)
7" (179 mm)
Tubing Size
Ice
Water
Up To Ice
Machine
Pressure
Machine
Fitting
Minimum
20 psi
1/4"
(137.9 kPA)
(6 mm) OD
Minimum
Maximum
Copper
Outside
80 psi
Tubing
Diameter
(551.5 kPA)
3/4"
(19 mm)
---
(19 mm)
Minimum
Hose Barb
Diameter
3/8"
---
(9 mm)
Minimum
Hose
Diameter
Section 2
Fitting
1/4"
(6 mm)
3/4"
Inside
3/8"
(9 mm)
Inside
Publicidad
