Manitowoc UP0050 Manual De Instrucciones página 26

Maintenance
Removal of Parts for De-scaling/Sanitizing
1. Turn off the electrical and water supply to the ice
machine.
n
Disconnect electric power to the ice machine before
proceeding with any of the following procedures.
2. Remove all ice from the bin.
3. Remove the components that must be de-scaled
and sanitized. See the following pages for removal
procedures for these parts.
n
Wear rubber gloves and safety goggles (and/or face
shield) when handling De-scaler or Sanitizer.
4. Soak the removed part(s) in a properly mixed solution of
de-scaler.
Solution Type Water
De-scaler 1 gal. (4 l)
000000084
Sanitizer 2 gal. (8 l)
9405653
5. The de-scaler will foam; once the foaming stops use a
soft-bristle nylon brush, sponge or cloth (NOT a wire
brush) to carefully de-scale the parts.
,
Do not mix Metal Safe De-scaler and Sanitizer solutions
together. It is a violation of Federal law to use these
solutions in a manner inconsistent with their labeling.
,
Do not immerse the water pump motor in the de-scaling
or sanitizing solution.
6. Thoroughly rinse all the parts with clear water.
7. Soak the removed parts in a properly mixed solution of
sanitizer for 5 minutes.
8. Use a soft-bristle nylon brush, sponge or cloth (NOT a
wire brush) to carefully sanitize the parts.
9. Use the sanitizing solution and a sponge or cloth to
sanitize (wipe) the interior of the ice machine and bin.
10. Rinsing is not required when using Manitowoc Sanitizer.
11. Install the removed parts.
12. Turn on the water and electrical supply.
26
Warning
Warning
Solution Amount
8 oz (240 ml)
1 oz (30 ml)
Caution
Caution
TOP COVER
1. Disconnect power to the ice machine.
2. Remove two back screws.
3. Slide top cover backward slightly and lift cover off.
Part Number 0000017452 Rev 00 06/22
Section 4
1
2