Publicidad
Idiomas disponibles
Idiomas disponibles
Section 4
BIN LIGHT
If the ice machine is shut down for a long period of time the
bin light cover must be de-scaled and sanitized. The light is
provided for your convenience. If you experience operational
problems with the light a replacement appliance bulb can be
obtained from your local hardware store.
FRONT GRILL
1. Remove two screws.
2. Tilt top forward and lift.
Part Number 0000017452 Rev 00 06/22
WATER FILTER
To replace the water filter incoming water does not need
to be turned off. This system is equipped with an internal
shut-off valve.
1. Turn cartridge slowly to the left, about 1/4 turn, until it
stops. At this position, both inlet and outlet ports are
closed and water pressure has been relieved.
2. Pull used cartridge forward to remove, then discard.
There may be a small amount of residual water drainage
after pressure is relieved and during cartridge removal.
3. Remove cap from top of new cartridge and push new
cartridge into filter head. Turn cartridge 1/4 turn to the
right until it stops. Top surface of cartridge will become
flush with bottom of the head when fully engaged.
4. Run a 3-minute fill cycle of the ice machine to flush the
filter. Then power off unit and restart to begin a new fill
sequence and ice making cycle.
5. Press and hold the Clean button for 6 seconds to reset
the counter and de-energize the filter light.
Maintenance
29
Publicidad
