EUFAB AMBER 3 Manual De Instrucciones página 10

Step 2
Components
Mounting the wheel rails
Two wheel rails form a pair. Place three pairs of wheel rails, with the plastic
shells on the outside, so that they are parallel on the base frame and the
drilled holes in the rail match the holes in the base frame. Secure each wheel
rail to the base frame with the lock screws M6 x 50, washers and self-tapping
nuts M6.
Securing the light mount to the base frame
Insert the cross-headed screws M5 x 35 with spring washers and washers,
from below, through the vertical drilled holes of the lamp mount. Insert the
screws through the threaded holes on the underside at the end of the lamp
mount. Tighten the screws.
Make sure that the fog light is installed on the left side of the mount!
Step 3
Components
Montage
The U-tube is delivered approx. 5 cm wider at the lower end
than the receptacles, i.e. the tubes are not parallel when
loose. During assembly, the ends of the tubes must be strongly
pressed together.
The purpose of the pre-tensioning is, the U-tube can be folded
down „rattle-free" for space-saving stowage.
Place the U-tube on the U-tube mount of the base frame. Secure the U-tube
with the supplied lock screws (M8 x 60), washers and knob nuts M8. The knob
nuts must be mounted on the inside (see photograph).
Caution: You must tighten both knob nuts very fi rmly to ensure that the U-tu-
be is fl ush against the U-tube mount.
9