EUFAB AMBER 3 Manual De Instrucciones página 11

Step 4
Components
Mounting the frame holder
Undo the handle screw of the frame holder and rotate out fully. Open the
cuff of the frame holder and place the inserts around the U-tube at a position
suitable for your bicycle. Place the cuff around the inserts and push fi rmly
together. Close the frame holder using the handle screw (but do not tighten).
Inserting the license plate
The mounting clips for securing the license plate are push-out parts in the
holder. Break out two of the clips. Slide the license plate into the holder, then
push the clips into the cut-outs to secure the license plate.
Cut-outs Clips
Laying electrical cables
Secure the cables of the lights to the underside of the rack using the supplied
cable ties. Make sure that the cables cannot be damaged when lowering and
raising the rack.
Mounting the short tensioning straps
Insert the short tensioning strap from the inside to the outside below the bike
holder and then from the outside to the inside through the slots of the bike
holder (see photograph).
Attaching the plastic covers
Fit the plastic covers onto the middle of the wheel rails.
10
Cut-outs
Mounting the bicycle rack on the trailer tow bar
Before you put the bicycle rack on the trailer tow bar, familiarise yourself with
the quick locking system.
Set bolt Safety pin
Set bolt
Ensure that the trailer tow bar is undamaged, clean and free of grease.
The quick locking mechanism is a component with a lever. Activating the lever
opens or closes the quick locking mechanism. With the help of the securing
bolt and the padlock, the quick locking system may be locked and secured.
The padlock must always be used as additional security
when using the bicycle rack.
Park your vehicle on a level surface. Switch the motor off and pull on the brake.
Remove the securing bolt from the quick locking mechanism and rotate by
90° to prevent it from engaging again. Open the quick locking mechanism by
lifting the lever.
Place the rack, from above, horizontally onto the trailer tow bar. Push the
lever of the quick locking mechanism down (force required is approximately
35 - 40kg) as far as it will go (the lever will remain in the horizontal position).
Check whether the bike rack is securely and fi rmly positioned on the trailer
tow bar and can no longer be rotated. If this is not the case, the quick locking
mechanism must be readjusted. Lift the lever and remove the rack from
the trailer tow bar. Undo the lock nut of the adjusting screw and rotate the
adjusting screw on the quick locking mechanism tighter by a quarter turn.
Then tighten the lock nut again.
Replace the rack back on the trailer tow bar and check whether the rack is
securely and fi rmly positioned on the tow bar. Repeat the adjustment process
until the rack is secure and fi rm.
CAUTION
Always make sure that the lock nut of the adjusting
screw is correctly tightened!
Slight signs of pressure on the two bar ball are normal
and do not infl uence the functionality.
When the rack is fi rmly seated on the trailer tow bar, rotate the securing bolt
of the quick locking mechanism until it engages. Now close the quick locking
mechanism with the supplied padlock and remove the key from the lock.
Store the key carefully and in a safe place. The bicycle rack is now secured to
prevent theft.
Regularly check the fi rm seating of the rack on the trailer tow bar as well as
the attachment of the bicycles to the rack. Also regularly check the functions
of the lighting system of your bicycle rack.
Lever
Lock
Lock nut